ABB ACS150 series, Руководство пользователя

Страница: 97 / 173

96
Actual signals and parameters
Parameters in the Long parameter mode
Index Name/Selection Description Def
16 SYSTEM
CONTROLS Run enable, parameter lock etc.
1601 RUN ENABLE Selects a source for the external Run enable signal. 0 = NOT SEL
0 = NOT SEL Allows the drive to start without an external Run enable signal.
1 = DI1
External signal required through digital input DI1. 1 = Run enable. If Run
enable signal is switched off, the drive does not start or coasts to stop if it is
running.
2 = DI2 See selection DI1.
3 = DI3 See selection DI1.
4 = DI4 See selection DI1.
5 = DI5 See selection DI1.
-1 = DI1(INV) External signal required through inverted digital input DI1. 0 = Run enable.
If Run enable signal is switched on, the drive does not start or coasts to stop
if it is running.
-2 = DI2(INV) See selection DI1(INV)
-3 = DI3(INV) See selection DI1(INV)
-4 = DI4(INV) See selection DI1(INV)
-5 = DI5(INV) See selection DI1(INV)
1602 PARAMETER LOCK Selects the state of the parameter lock. The lock prevents parameter
changing from the control panel. 1 = OPEN
0 = LOCKED Parameter values cannot be changed from the control panel. The lock can be
opened by entering the valid code to parameter
1603 PASS CODE.
The lock does not prevent parameter changes made by macros.
1 = OPEN The lock is open. Parameter values can be changed.
2 = NOT SAVED Parameter changes from the control panel are not stored into the permanent
memory. To store changed parameter values, set parameter
1607 PARAM
SAVE value to 1 (SAVE).
1603 PASS CODE Selects the pass code for the parameter lock (see parameter 1602
PARAMETER LOCK).
0
0
…65535
Pass code. Setting 358 opens the lock. The value reverts back to 0
automatically.
1604 FAULT RESET SEL Selects the source for the fault reset signal. The signal resets the drive after
a fault trip if the cause of the fault no longer exists. 0 = KEYPAD
0 = KEYPAD Fault reset only from the control panel
1 = DI1 Reset through digital input DI1 (reset on the rising edge of DI1) or from the
control panel
2 = DI2 See selection DI1.
3 = DI3 See selection DI1.
4 = DI4 See selection DI1.
5 = DI5 See selection DI1.
7 = START/STOP
Reset along with the stop signal received through a digital input, or from the
control panel.
-1 = DI1(INV) Reset through inverted digital input DI1 (reset on the falling edge of DI1) or
from the control panel
-2 = DI2(INV) See selection DI1(INV).