ABB ACS150 series, Руководство пользователя

Страница: 53 / 173

52
Start-up and control with I/O
50
.
0
Hz
PAR SET FWD
60
.
0
Hz
PAR SET FWD
The general parameter setting procedure in the Short parameter mode:
1. To go to the Main menu, press if the bottom line shows OUTPUT;
otherwise press repeatedly until you see MENU at the bottom.
2. Press keys
/
until you se
e “PAr S” on the display.
3. Press . The display shows a parameter of the Short parameter mode.
4. Find the appropriate parameter with keys
/
.
5. Press and hold for about two seconds until the parameter value is
shown with SET under the value.
6. Change the value with keys
/
. The value changes faster while
you keep the key pressed down.
7. Save the parameter value by pressing .
LOC
LOC
LOC
LOC
LOC
LOC
LOC
rEF
MENU FWD
PAr S
MENU FWD
9902
s
PAR FWD
9907
s
PAR FWD
9907
s
PAR FWD
Enter the motor data from the motor nameplate: Note : Set the motor data
to exactly the same value
3 motor
ABB Motors
M2AA 200 MLA 4
IEC 200 M/L 55
No
Ins.cl. F
IP 55
as on the motor
nameplate. Wrong motor
settings of parameter
group 99 may result in
V
Hz kW r/min A cos IA/IN t E/s
690 Y
400 D
660 Y
380 D
415 D
440 D
50
30
50
30
50
30
50 30
50 30
60
35
1475
1475
1470
1470
1475
1770
32.5
56
34
59
54
59
0.83
0.83
0.83
0.83
0.83
0.83
380 V
supply
voltage
incorrect operation of the
drive.
For example, if the motor
nominal speed is 1440
Cat. no
6312/C3
3GAA 202 001 - ADA
6210/C3
IEC 34-1
180
rpm on the nameplate,
setting the value of
parameter
9908 MOTOR
NOM SPEED to 1500 rpm
results in the wrong
operation of the drive.
• motor nominal voltage (parameter
9905 MOTOR NOM
VOLT)
– follow steps given above, starting from step
4.
• motor nominal current (parameter
9906 MOTOR NOM
CURR)
Allowed ran
ge: 0.2…2.0 ·
I
2N
A
LOC
9905
s
PAR FWD
LOC
9906
s
PAR FWD