ZyXEL Communications EX3510-B1, User Manual

Page: 146 / 313

EX3510-B1 User’s Guide
146
C
HAPTER
10
Quality of Service (QoS)
10.1 QoS Overview
Quality of Service (QoS) refers to both a network’s ability to deliver data with minimum delay, and the
networking methods used to control the use of bandwidth. Without QoS, all traffic data is equally likely
to be dropped when the network is congested. This can cause a reduction in network performance and
make the network inadequate for time-critical applications such as video-on-demand.
Configure QoS on the Zyxel Device to group and prioritize application traffic and fine-tune network
performance. Setting up QoS involves these steps:
1
Configure classifiers to sort traffic into different flows.
2
Assign priority and define actions to be performed for a classified traffic flow.
The Zyxel Device assigns each packet a priority and then queues the packet accordingly. Packets
assigned a high priority are processed more quickly than those with low priority if there is congestion,
allowing time-sensitive applications to flow more smoothly. Time-sensitive applications include both
those that require a low level of latency (delay) and a low level of jitter (variations in delay) such as
Voice over IP (VoIP) or Internet gaming, and those for which jitter alone is a problem such as Internet
radio or streaming video. There are eight priority levels, with 1 having the highest priority.
This chapter contains information about configuring QoS and editing classifiers.
10.1.1 What You Can Do in this Chapter
• The General screen lets you enable or disable QoS and set the upstream bandwidth ( Section 10.3 on
page 148 ).
• The Queue Setup screen lets you configure QoS queue assignment ( Section 10.4 on page 150 ).
• The Classification Setup screen lets you add, edit or delete QoS classifiers ( Section 10.5 on page 152 ).
• The Shaper Setup screen limits outgoing traffic transmission rate on the selected interface ( Section
10.6 on page 157 ).
•
The Policer Setup screen lets you control incoming traffic transmission rate and bursts ( Section 10.7
on page 158 ).
• The Monitor screen lets you view statistics of QoS on WAN/LAN interface and the status of queues
( Section 10.8 on page 161 ).