1-3
IM 703155-01E
1
Names and Functions of Parts
1.2
Setup Menu Display/Execution Key
Setting Output Conditions
CLOCK Key
(Sections 5.1 to 5.3)
Displays a menu use to set the 10-MHz reference signal, clock signal, and clock
frequency.
WAVE Key
(Chapter 4, sections 5.4 to 5.6)
• Displays a menu used to load waveform data and set the gain, phase, IQ gain ratio,
quadrature offset, voltage offset, low-pass filter, noise, and output shift.
• Displays a selection menu used to set the waveform output to analog or digital signal.
SEQ Key
(Chapter 7)
Displays a menu used to edit, save, and load the sequence list that specifies the order of
waveform data generation.
TRIG Key
(Sections 6.1 and 7.2)
Displays a menu used to set the trigger or sequence trigger (option) that starts signal
generation.
OUT1 to OUT4 Keys
(Sections 5.4 to 5.6, chapters 7 and 8)
Used to select the output terminal set (OUT1 to OUT4) on the screen that appears when
the WAVE key or SEQ key is pressed.
Executing Signal Output
START/STOP Key
(Section 6.2)
Starts/stops signal generation.
ON/OFF Key
(Section 6.2)
Controls the signal output ON/OFF. The signal output must be turned ON using this key
for the signal to be output when signal generation is started.
Checking the Output Waveform
DISP Key
(Chapter 8)
• Displays a menu used to set the waveform, spectrum, CCDF, constellation, and eye
displays.
• Displays a menu used to move the markers on the displayed waveform and set the
auxiliary display (display interpolation, graticule, waveform label, and scale values).
Additional Functions
APPLI Key
Starts a software application that is registered in the VB8300.
HDD
OPTION
MISC
FILE
CLOCK
MANUAL
TRIG
WAVE
SEQ
TRIG
DISP
OUT 1
OUT 2
OUT 3
OUT 4
START/STOP
ON/OFF
OUTPUT
HDD
OPTION
MISC
FILE
CLOCK
MANUAL
TRIG
WAVE
SEQ
TRIG
DISP
OUT 1
OUT 2
OUT 3
OUT 4
START/STOP
APPLI
