xvi
Wiring Precautions
NOTICE
Do not install or store the product in any of the following locations.
•
Locations that are subject to direct sunlight
•
Locations that are subject to ambient temperatures that exceed product specifications
•
Locations that are subject to relative humidities that exceed product specifications
•
Locations that are subject to condensation as the result of extreme changes in temperature
•
Locations that are subject to corrosive or flammable gases
•
Locations that are near flammable materials
•
Locations that are subject to dust, salts, or iron powder
•
Locations that are subject to water, oil, or chemicals
•
Locations that are subject to vibration or shock that exceeds product specifications
•
Locations that are subject to radiation
If you store or install the product in any of the above locations, the product may fail or be damaged.
The Magnetic Way of a Linear Servomotor uses a strong permanent magnet. To ensure safety
and prevent accidents, observe the following precautions when you install the Linear Servomo-
tor.
Do not work on a Magnetic Way with electronic devices (such as clocks, calculators, or computers)
or magnetic storage media (such as IC cards or magnetic cards) on your person or bring such
devices or media near a Magnetic Way.
The influence of the magnetism may cause the device or media to malfunction or fail.
Use the product in an environment that is appropriate for the product specifications.
If you use the product in an environment that exceeds product specifications, the product may fail
or be damaged.
A SERVOPACK or Servomotor is a precision device. Do not drop it or subject it to strong shock.
There is a risk of failure or damage.
In an application where the Servomotor would be subjected to large quantities of water or oil,
implement measures to protect the Servomotor from large quantities of liquid, such as installing
covers to protect against water and oil.
In an environment that contains magnetic substances, such iron cuttings or powder, implement
measures to prevent the magnetic substances from adhering to or entering the product. Be par-
ticularly careful not to let foreign matter, such as metals, enter the gaps between a Magnetic
Way and Moving Coil.
If foreign material adheres in the gaps between a Moving Coil and Magnetic Way, operation may
stop or burning may occur.
D
A
NGER
Do not change any wiring while power is being supplied.
There is a risk of electric shock or injury.
W
A
RNING
Wiring and inspections must be performed only by qualified engineers.
There is a risk of electric shock or product failure.