7.2 Installation Procedure
7.2.2 SGLF Servomotors (Models with F-type Iron Cores)
7-6
3.
Place the Moving Coil on top of the Magnetic Way.
4.
Attach the second and any other Magnetic Ways.
This concludes the procedure.
Mounting the First Magnetic Way
Use the following procedure.
If you will use only one Magnetic Way, the linear motion guide may not be sufficiently long
enough to install the Moving Coil at a location separated from the Magnetic Way. Install a
dummy linear motion guide and use it to mount the Moving Coil.
When a Magnetic Way is shipped, the side with the magnets is covered with cardboard onto
which thin rectangular steel plates are placed.
The steel plates are dummy plates that are used to reduce the influence of the magnetism on the
surroundings. When you remove the plates, be careful not to pinch your fingers and to not dam-
age the magnets or magnet cover.
The magnets in the Magnetic Way exert a very strong magnetic attraction. Be very careful when
you use steel screws, wrenches, or other metal objects.
Important
Magnetic Way
Proper linear motion guide
Dummy linear motion guide
Moving
table
Blocks
Moving Coil
Second and any other Magnetic Ways
Note
Dummy plate to
reduce magnetic force
Magnetic Way yoke
Cardboard
Magnet
Magnet Cover
Condition with Cardboard Removed
Nameplate
Note