Yamatake MagneW3000 PLUS, User Manual

Page: 65 / 134

4 - 12
Operating in Operator’s Mode
Introduction The Operator’s Mode includes the following settings and adjustments.
To enter the Operator’s Mode, touch the MODE key for more than three sec-
onds.
Screen display Description Indicated conditions
AUTO ZERO Performs zero adjustment
Sets the damping time con-
stant DAMPING
Sets the reset value of the
built-in flow counter CNT-RESET VALUE
Selection of pulse output
and TOTAL display.
Resets the built-in flow
counter to the reset value
CNT-RESET Selection of pulse output
and the TOTAL display.
Selection of pulse output
(in selective specifications)
and setting of counter pre-
set (in function setting). Sets the preset value of the
built-in flow counter COUNTER PRESET
Sets the flow rate display DISPLAY SELECT
Enters the Engineering
Mode MODE ENTER
ENGINEERING
Enters the Maintenance
Mode MODE ENTER
MAINTENANCE Setting of write protect to
level 0.
Details of the screens are explained on the following pages using concrete
examples. To display the various screens, enter the Operator’s mode and then
press the key.
Note:
• Settings and adjustments made in the Operator’s Mode are tempo-
rarily written into memory when input. However, the settings will
return to their previous status unless the data are saved within 2
minutes. Be sure to save the data by pressing the MODE key at
the end of setting/adjustment.