Yamatake MagneW3000 PLUS, User Manual

Page: 111 / 134

4 - 58
Setting the Contact Output Status
Introduction This is used to set the contact output status for normal operation.
Important
This function is displayed when contact output has been selected (additional
specification).
Default setting
"CLOSE"
Setting range
"CLOSE" "OPEN"
For 1-contact input and 1-contact output
Open the contact output status
setup screen by following the
steps to enter the Engineering
Mode.
Touch the key.
Use the key to set the con-
tact output status.
Touch the key to move the
cursor to the "#".
1
Screen Procedure Step
2
3
4
(Continued on next page)
# ST. OUT MODE
NORMAL CLOSE
# ST. OUT MODE
NORMAL CLOSE
# ST. OUT MODE
NORMAL OPEN
# ST. OUT MODE
NORMAL OPEN