Yamatake MagneW3000 PLUS, User Manual

Page: 78 / 134

4 - 25
Selecting Functions
Introduction Sets the electromagnetic flowmeter functions: range, counter, contact input,
and contact output.
There will be restrictions on the functions that can be set depending on your
model's specifications. Note that the setting range will be limited depending
on whether or not a pulse output board is used and the kind of contact input/
output boards.
The possible combinations are shown on the following pages.
Open the function setup screen
by following to the steps to en-
ter the Engineering Mode.
Touch the key to select the
kind of function settings.
One touch is for range setting,
two touches for built-in counter
setting, three touches for the
contact input function setting,
and four touches for the contact
output function setting.
Screen Step
1
Touch the or key to select
the desired function.
Two touches of the key in
Step 1 enables the selection of
the built-in counter function.
Touch the or key to select
the desired function.
Three touches of the key in
Step 1 enables the selection of
the contact input function.
Touch the or key to select
the desired function.
2
3
4
5
(Continued on next page)
Procedure
# FUNC SET F0A11
# FUNC SET F0A11
SINGLE RANGE
# FUNC SET F1A11
DIR AUTO DUAL RG
# FUNC SET F0B13
PRESET COUNTER
# FUNC SET F0A21
EXT AUTO ZERO