9
2. Preparation
⚠
After receiving the
TranSERVE® you need
to perform a FLUID PRIMING
operation, or drain out test fluid
from the unit.
• After selecting the MACHINE PRIMING
function, press button. The following message
will then appear :
Load at Least 3.5L
of Fresh Fluid and
couple the hoses
• Perform the operations indicated in the message,
feeding at least 3.5 litres of new fluid, coupling the
connection hoses of the TranSERVE® by means of
fitting no. 5, included in the complete set of fittings
WF4324 (standard kit).
• Press button.
• The TranSERVE® will start drawing fluid from the
NEW fluid tank and will discharge the fluid present
in the internal circuit into the Used fluid tank.
New 4.8L
Used 0.5L
†0.0L Set 2.0L
• Check through the visual indicator (“1.3 - Control
panel” on page 8, point
➊
), that the oil flowing
in the circuit with smooth flow. If the oil does not
flow or it detects the
presence of air in the
system, open the purge
valve (Ref. a) to bring
down into the tank a small
amount of oil, and
immediately close the
valve.
⚠
Open the purge tap ONLY
for the Machine Priming
operation! Ensure that the valve is
always closed before starting the
operation of the ATF exchange.
• For a few minutes the display will show the
quantity of fluid present in the two tanks.
New 3.5L
Used 1.8L
†2.0L Set 2.0L
Please Wait...
• At the end of the operation the following message
is shown:
OPERATION COMPLETED.
• Long press .
• Ensure that the NEW FLUID tank contains the
quantity of fluid that you need to change. We
advise changing two litres more than the quantity
indicated as nominal content of “dry” gearbox.
• Place the NEW FLUID tank in the rear
compartment of the TranSERVE® (NEW
↑
), as
shown in “1.2 - Machine parts” on page 8, point
➎
.
• Ensure that the volume remaining in the USED
FLUID tank is sufficient to receive the total quantity
of fluid that will be replaced, otherwise the used
fluid will overflow from the tank.
• Place the USED FLUID tank in the rear
compartment of the TranSERVE® (
↓
EXH.), as
shown in “1.2 - Machine parts” on page 8, point
➍
.
• When positioning the TranSERVE® for any type of
process, you should make sure that at least the two
GREEN and RED indicator lights are visible.
• Connect the TranSERVE® to the car battery: the
black clamp to the negative pole (-) and the red
clamp to the positive pole (+).
⚠
The unit works only with
12 Volt. If power supply is
not correct, the machine will not
turn on.
⚠
Before proceeding with the
FLUID REPLACEMENT
phase ensure that the type of fluid
shown in the fourth line on the
display is the same as the fluid
in the NEW FLUID tank. If you
want to change fluid type, you
need to read “5.2 - Fluid Type” on
page 16. Check the tank tare, if
different from the original tanks
supplied. IT IS IMPORTANT that
you do not change the original
USED FLUID tank supplied with
another tank; if you need to do so
you must first follow the simple
procedure described in “5.4 - Used
Tank Tare” on page 16.
a
