13
if the temperature of the fluid of
the vehicle has not reached at least
40 °C. Therefore, on the display,
you will see the related messages of
waiting for the heating of the fluid.
For a short time the TranSERVE® will check the
direction of flow of the fluid.
Checking flow...
Please Wait...
If the fluid is not sufficient or if the flow is not
normal, the cycle stops; this will be indicated by the
RED – WARNING light flashing and by the
message “INSUFFICIENT FLUID FLOW” on the
display unit. If the flow direction check is positive,
the cycle for total replacement of used/old fluid
with new fluid will start automatically and include
the radiator: the new fluid is pumped with the same
speed and exact quantity with which the used fluid
is drained out, until the preset quantity is reached.
New 3.6L
Used 0.7L
†0.9L Set 1.0L
†0.7L
The display will show variations in the content of
the two tanks. When the exchange of the preset
quantity is completed, the GREEN light will go
from flashing to permanently on. The TranSERVE®
will automatically go into “LOOP”, which means the
connection between transmission and radiator is
closed and the pump stopped.
4.6. ATF exchange - Protection
additive – Wynn’s Automatic
Transmission Treatment
At the end of the fluid replacement
cycle, the display asks whether
protection additive is to be added.
Load Final additive
or push ESC to skip
• Unscrew the stopper on top of the
TranSERVE®, pour the product into the auxiliary
tank and after screwing the stopper back on, press
button.
⚠
The operation must be
performed only with the
stopper screwed on.
The protection additive will be injected.
Additive
NOTE: The injection of additives always takes
into account the exact quantity of fluid
contained in the delivery hose, and then the
TranSERVE® automatically adds the rest,
followed by the quantity of fluid, to ensure that
part of the additive does not remain inside the
hose.
• At the end of the operation the display of the
TranSERVE® will show the message:
Operation
completed
• Once this operation has been completed, the
TranSERVE® will automatically go into “LOOP”,
which means the connection between transmission
and radiator is closed and the pump stopped.
• If you choose not to add the Protection additive,
long press and the display will show the initial
READY page.
New 15.0L
Used 3.9L
Auxiliary Empty
Generic ATF 30C
• Stop the engine of the vehicle.
• Remove the hoses and adaptors from the gearbox
and from the radiator.
• Connect the original hose back on the gearbox.
• Start the engine and check for leaks.
• Check the fluid level in the automatic
transmission, if needed top up or drain out.
• Disconnect the TranSERVE® from the vehicle’s
battery.
• Wipe off any fluid residues from the connectors
and tool tray.
• Empty out the USED FLUID tank, in conformity
with regulations on disposal.
4.7. Fluid top-up
This function is used to feed fluid from the NEW
tank into the gearbox, with engine off or on.
This top-up can be performed in different ways,
depending on the type of transmission. Follow the
instructions provided by the vehicle manufacturer
for correct level check. Use specific adaptors for
connection between TranSERVE® and transmission
system.
• From the READY page press button.
