14
New 15.0L
Used 3.9L
Auxiliary Empty
Generic ATF 30C
• Use the button to select the FLUID TOP-UP
function.
ATF Exchange
•Fluid Top Up
Fluid Drain
Additive Load
• Press .
• Enter the quantity of fluid to be topped up, using
the button, and press to confirm.
Fluid Top Up
Amount:
10.0L
⚠
The NEW FLUID tank must
contain a sufficient quantity
of fluid, including an extra two
litres. Otherwise, the display of the
equipment will show the message:
“INSUFFICIENT NEW FLUID”.
New 4.6L
Used 1.0L
†0.2L Set 0.5L
At the end of the operation the display will show
the READY page again.
New 15.0L
Used 3.9L
Auxiliary Empty
Generic ATF 30C
4.8. Fluid draining
The TranSERVE® is connected with the automatic
transmission system.
This function is used to drain out excess fluid,
in other words “get the right level”, which should
always be done when the fluid has reached the
temperature indicated by the manufacturer.
• From the READY page press .
New 15.0L
Used 3.9L
Auxiliary Empty
Generic ATF 30C
• Turn button to select FLUID DRAIN.
ATF Exchange
Fluid Top Up
•Fluid Drain
Additive Load
• Press button.
• Use the button to enter the quantity of fluid to
be discharged in the USED FLUID tank.
Fluid Drain
Amount:
10.0L
• Confirm by pressing .
⚠
Check the USED FLUID tank
to ensure there is enough
volume to receive the fluid that is
going to be drained out.
⚠
The draining phase will
not be carried out at
temperatures below 40°C. Only in
this case the following message will
be shown.
Fluid is too cold
wait for warmup
• Press .
30C
Waiting for fluid to
warm up...
The TranSERVE® will automatically perform
draining of the previously selected quantity without
any warning as soon as the temperature of 40°C has
been reached. This procedure normally follows the
performance of the complete fluid replacement
cycle, therefore the fluid temperature will in fact
always be above 40°C and there will be no need to
wait.
New 4.6L
Used 1.0L
†0.2L Set 0.5L
• At the end of the cycle the GREEN light will
remain on fixed.
• Press . The display goes back to READY and the
GREEN light goes off.
New 15.0L
Used 3.9L
Auxiliary Empty
Generic ATF 30C
4.9. Additive loading
This function is used to feed a protection additive
from the auxiliary tank of the TranSERVE® to
the vehicle transmission, with engine off or on.
This top-up can be performed in different ways,
depending on the type of transmission.
