Parameters
Device Planning Parameters
Device Planning Parameters
are part of the Parameter Tree.
•
Improving the Usability (clearness):
All protection modules that are currently not needed can be
•
de-protected (switched to invisible) by means of Device Planning. In Menu Device Planning you can adapt
the scope of functionality of the protective device exactly to your needs. You can improve the usability by
de-projecting all modules that are currently not needed.
•
Adapting the device to your application:
For those modules that you need, determine how they should
work (e.g. directional, non-directional, <, >...).
Direct Commands
Direct Commands
are part of the Device Parameter Tree but they are
NOT
part of the parameter file. They will be
executed directly (e.g. Resetting of a Counter).
State of the Module Inputs
Module Inputs
are part of the Parameter Tree. The State of the Module Input is context-dependent.
By means of the Module Inputs influence can be taken on the Modules. You can assign Signals onto
Module
Inputs
. The state of the signals that are assigned to an input can be taken from the Status Display. Module Inputs
can be identified by an
„-I“
at the end of the name.
Signals
Signals
are part of the Parameter Tree. The state of the signal is context-dependent.
•
Signals
represent the state of your installation/equipment (e.g. Position Indicators of the Circuit Breaker).
•
Signals
are assessments of the state of the grid and the equipment (System OK, Transformer failure
detected...).
•
Signals
represent decisions that are taken by the device (e.g. Trip command) based on your parameter
settings.
283
MRU4
DOK-HB-MRU4-2E
