UD100 User Guide Document: UD100-3
----------------------------------------------------------------------------------------------------------------------------- -----------
81
➢
No software driver is required for PC Tool. Once user opens PC Tool and connects with PC
through Ethernet or USB, user can execute edge blending settings through PC keyboard and
mouse. After finish the setup, user can save the result to Box and no more PC is required.
➢
User can backup system setting in PC and copy to other units.
➢
Firmware and MCU code update can be executed through Gwarp3. User can control multiple
units at the same time through different IP address.
11.2.1. Important concept
➢
Gwarp3 is a PC tool for convenient operation through USB or Ethernet connection.
➢
Geometry alignment in Gwarp3 is called [Warp Adjust]. OSD or Remote controller adjustment
can execute geometry alignment up to 17x9 control points but Gwarp3 may be up to 33x33.
➢
Under 17x9 control point, the geometry result in Gwarp3 will be executed to the Box in real
time. It is the same result as OSD or remote controller operation. User can switch operation
between remote controller and Gwarp3 at any time.
➢
The data saved in Gwarp3 through [Save Setting] to PC can be as backup or copied to another
unit. It is editable and user can execute further modification.
