UD100 User Guide Document: UD100-3
----------------------------------------------------------------------------------------------------------------------------- -----------
76
10. Multiple unit applications
10.1.
System connection in multiple unit edge blending
➢
Connect input signal to HDMI 1/4/7/10 input ports and loop out to next processing channel input
port. The last loop out port can be connected to next UD100. No special sequence is required.
➢
Usually, loop out signal can connect up to 10 processing channels. The maximum number is
related to signal resolution and HDMI cable quality. If more channels are required, please add one
HDMI splitter at the front end. It will extend to double or triple numbers of processing channels.
➢
In edge blending application, only HDMI-1/4/7/10 signal can be cascaded through internal HDMI
splitter. If user wants to do edge blending with other input ports, please add video distributor at the
front end and feed the signal to all UD100 processing modules. Each UD100 has up to 4
processing modules.
➢
User can control UD100 through Ethernet, USB or remote controller.
➢
IF GeoBox is installed in control room, Ethernet control will be the most convenient. Notebook,
mobile phone and Pad can execute GeoBox setup through Ethernet or WiFi.
➢
User can set individual Box ID and IP address for easy independent control in each GeoBox.
➢
Select input port and set GeoBox output resolution to be the same as projector native resolution.
➢
User needs to apply a signal source while executing video wall [Overlap] value setting. Signal
source resolution should be the same as VNS Excel Spread Sheet calculation. To apply 4K or
higher signal resolution is recommended. After system setup, user can use any input resolution.
➢
Press [INFO] hotkey to check if the final in/out timings are the same as expected.
