UD100 User Guide Document: UD100-3
----------------------------------------------------------------------------------------------------------------------------- -----------
15
➢
Poor quality HDMI cable and signal source will affect the connection distance and may cause
signal noise or show intermittent image.
➢
To ensure all cables are connected correctly, it is recommended to use locking cables. We can
provide T-Lock cable with certified quality.
➢
Complete edge blending system should be connected to one power Distribution Box with proper
grounding. Power on the system after finishing all connections to avoid system damage by floating
voltage among devices.
➢
When power is switched on, the booting time is about 20 seconds (different input source and
HDCP may have different booting time) and the Input & Output LEDs on front panel will stay
“Light-
up
” all the time for the channel with correct input source and output device connections.
➢
If continuous flashing in power LED, it means the OSD function has been Locked. Please press
[Menu] key for 5 seconds to disable [OSD Locked] function. If system lock is done by remote
controller through [85x] operation, please press [850] to unlock system control.
2.4. System Reset
User can rest system through below method:
➢
User small pin to insert RESET hole at back panel for 5 seconds, user will see [Reset to Default]
message. It will apply to all channels at the same time.
➢
Open OSD menu to reset the system. It will only be functional in one channel.
➢
User [Reset] hotkey on remote controller will go to Reset OSD menu for one channel only.
➢
When operating through OSD or remote controller, user can select to reset [Reset All], [Video Wall
setting] or [Anyplace] (geometry) setting.
➢
Reset from OSD or remote controller will not delete Profile Index data. RESET from RESET Hole
on back panel will delete Profile Index data.
T-Lock cable
