UD100 User Guide Document: UD100-3
----------------------------------------------------------------------------------------------------------------------------- -----------
29
3.1.5. Adjust aspect ratio or cropping area in main and sub-image
➢
User can change the cropping area and aspect ratio in main and sub-image images through
Overlap OSD menu. Each edge can adjust the overlap up to +_1800 pixels.
➢
When Overlap value is decreased, the image cropping area will be reduced and cause the image
have Zoom-In effect (enlarged). If the Overlap value is increased, the image cropping area will
increase and cause the image to have Zoom-out effect (shrunk).
Main image Overlap adjustment
Sub-image Overlap adjustment
3.2. PIP (Picture in Picture)
➢
Main & PIP input source is swappable.
➢
PIP image in each channel is independent. It is only inside one monitor but not across multiple
monitors.
➢
PIP and main
images can be rotated at 90/180/270 degrees independently to build different display styles.
➢
If one PIP image across multiple projectors is required, user can use one channel as front end to
implement PIP
function, then connect the output to the input port in edge blending channel to get it.
3.2.1. PIP [Size] and [Position]
➢
PIP image size is from 320*180 to 1920*1200.
➢
It can be further adjusted through Overlap function to get about 160*90 image size.
➢
User can replace main image with sub-image on entire display under FHD output resolution.
➢
The PIP image position can be at any location with pixel by pixel adjustment through [Overlap]
function.
