11
Multi-Lane
4/2022 (EN)
90˚
SW4
SW6
9 Nm
18 Nm
Fig. 18: Mounting the fixing set
NOTE
It must be noted that, even in the case of ceiling
rails mounted lying on top of one another, each
individual track is fastened to at least two suspen-
sion points.
Connecting the ceiling rails
90˚
SW6
20 Nm
Fig. 19: Connecting the ceiling rails
NOTE
The connection set and L, T and X connectors are
not designed for bearing loads.
Fitting the cover profile for L, X and T
connectors
Information:
Fitting the cover profile for L, X and T
connectors cannot be used for connectors with ceiling
attachment.
1
1
SW5
Fig. 20: Fitting the cover profile for L, X and T connectors (1)
Fitting the cover profile for the ceiling rail
1
2
11
1
Fig. 21: Fitting the cover profile (1) using a soft underlay (2)
Attaching the end cover
1
2
SW5
Fig. 22: Fitting the end cover for the ceiling rails
Screw in both screws (Fig. 22/1), leaving a gap of ap-
prox. 2–3 mm. Slide the end cover (Fig. 22/2) over and
tighten the screws.
Attaching the support and mounting profiles
Fig. 23: Attaching the support and mounting profiles
