23
Multi-Lane
4/2022 (EN)
8. Clamp the floor mounting and the merchandise sup-
port between the Multi-Lane rail and the floor with the
aid of an Allen key by rotating the adjustable slider.
9. Align spirit level vertically.
SW17
Fig. 56: Alignment
NOTE
Only twist out the floor slider so that the merchan-
dise support frame can no longer be moved on the
floor.
The Multi-Lane profile must be mounted on the ceiling
using a ceiling suspension mounting (318-545).
Alternative, the suspended mounting (994-019) is also
possible, however the weight force of the Multi-Lane
ceiling grid must be greater than the force generated by
rotating the slider.
By rotating the slider upwards, the Multi-Lane ceiling grid
must not be pressed upwards.
Shown additionally.
10. Slide the longitudinal connector tubes onto the pins
and dock onto the additional upright on the side.
Rotate 45° using the assembly tool.
11. For attaching the upright, proceed as is the case with
assembling the existing upright.
45°
45°
Fig. 57: New upright
5.1.2 Remove 24 V uprights
WARNING
During dismantling, the merchandise support could
fall over at any time.
>
The merchandise support must be firmly held
during dismantling.
1. Screw on the hanger adapter by rotating the screws
clockwise with the SW5 Allen key.
2. Loosen the two lateral clamping SW4 screws (1) and
move the clamping adapter into the lower position.
SW4
1
Fig. 58: Removing merchandise support
