17
Multi-Lane
4/2022 (EN)
4.8 Attaching the power supply
1. Insert the adapter from below into the slot on the
power track.
Fig. 38: Inserting the adapter into the power track
2. Clip the converter cover into the profile.
Fig. 39: Clipping the cover into the profile
4.9 Attaching the suspended merchandise
support frame with the sliding adapter
The merchandise support frames are disassembled when
delivered. The side parts are pre-assembled.
1. Mounting the connecting tubes to the side parts.
1.
2.
Fig. 40: Connecting the side parts to the tubes
NOTE
The connecting tubes must be rotated with the as-
sembly tool 111-844.12 and positioned properly.
WARNING
Risk of injury from goods or merchandise supports
falling down.
>
Never loosen the screws shown in the following
illustration.
WARNING
Risk of injury from goods or merchandise supports
falling down. The system can fail if the maximum
permissible load of the merchandise support is ex-
ceeded.
>
Observe the maximum load values of the indi-
vidual merchandise supports.
>
Do not exceed the maximum load of 160 kg per
frame.
>
The merchandise supports must only be moved in
the unloaded state.
WARNING
Risk of injury from falling merchandise supports.
During assembly, the merchandise support could
fall down at any time.
>
The merchandise support must be firmly held
during assembly.
2. Loosen screws on one side using an SW4/SW5 Allen
key and set the intermediate dimension to 55 mm.
55
Fig. 41: Prepare sliding adapter
