20
Multi-Lane
4/2022 (EN)
The Multi-Lane profile must be mounted on the ceiling
using a ceiling suspension mounting (318-545).
Alternatively, the suspended mounting (994-019) is also
possible, however the weight force of the Multi-Lane
ceiling grid must be greater than the force generated by
rotating the slider.
By rotating the slider upwards, the Multi-Lane ceiling grid
must not be pressed upwards.
6. Frames with floor mounting can be braked against
being moved. In addition, align the frames vertically
and unscrew the adjustable sliders using an SW17 Al-
len key. It is clamped between the Multi-Lane rail and
the floor. Check break action after several rotations
(min. 10x). Re-adjust if necessary
Fig. 48: Tension frames
WARNING
Only twist out the floor slider so that the merchan-
dise support frame can no longer be moved on the
floor.
4.11.2 Dismantling
1. Detach the floor mounting from the merchandise sup-
port by removing the screw using an SW8 Allen key
(with spherical head).
Fig. 49: Removing floor mounting
5 Operation of uprights
5.1 Uprights, 24 V
The system consists of steel uprights, the height of which
can be adjusted, with or with an integrated power rail for
electrifying shelves with an LED and hanging rails.
The pins on the steel upright are used to connected
several uprights to one another by means of connecting
tubes.
• Multi-Lane upright, outside 24 V DC, electrified and
non-electrified (A)
• Multi-Lane upright, in the centre 24 V DC, electrified
and non-electrified (A)
2900-3100
2900-3100
A
B
Connecting tube set
The connecting tubes are screwed on to the spigots on
the uprights. Use assembly key (111-844.12).
A 650
A 1300
Fig. 50: Connecting tubes
