28
Multi-Lane
4/2022 (EN)
4. Actuate brake.
The panel must be secured against falling over with
the brake integrated into the adapter!
5. Align the panel vertically and rotate out the adjust-
able slider with an SW17 Allen key. The panel is
clamped between the Multi-Lane rail and the floor.
Check break action after several rotations (min. 5x).
Re-adjust if necessary
Fig. 67: Unscrew adjustable screws
WARNING
If the brake has not been pulled enough, the panel
can fall over into the profile direction.
NOTE
Assembly must proceed according to the assembly
instructions. Otherwise, the equipment may not
work properly.
6.2 Removing Grid 50 panel with sliding
adapter
WARNING
Risk of injury from goods or merchandise supports
falling down. During dismantling, the merchandise
support could fall down at any time.
>
Hold the merchandise support firmly.
1. Loosen screws on one side using an SW4/SW5 Allen
key until the lateral sliding elements are fully visible.
Fig. 68: Removing merchandise support
2. The two people, carefully pivot the panel in the profile
direction and lay it down on the ground.
6.3 Attaching the panel receptacle with
the sliding adapter
Attach as is described under „6.1 Attaching Grid 50
panel with sliding adapter“.
The receptacle is designed for plate size
2454 mm x 400 - 1000 mm / plate thickness 25 - 38 mm.
Fig. 69: Wooden panel
400 - 1000
24
54
15
0
Fig. 70: Plate size
300
100
Ø
6
Fig. 71: Top and bottom screw attachment points
