Viessmann VITOCAL 350-A, Installation And Service Instructions Manual

Page: 148 / 256

148
Message
System characteristics Cause Measures
«
CF Communication module
Communication error -
LON module in heat
pump control unit Check LON communica-
tion module and replace if
required.
If required, replace in the
following order: PCB 3,
ribbon cables between
PCB 3 and 2, PCB 2.
«
D1 Compressor
Compressor fault:
Thermal compressor
relay or safety element of
full wave soft starter (if
installed) has respon-
ded.Separate compres-
sor motor protection (if
installed) has responded ■ Reset compressor ther-
mal relay, check setting,
restore delivered condi-
tion (
"Reset" , see oper-
ating instructions).
Check compressor
electrical connections,
test coil resistance of
compressor motor.
Check compressor
phase sequence.
The switching signal (of
thermal relay, full wave
soft starter, separate
motor protection) can
be tested at terminal
1X5.9 (230V).
Note
If overheating occurs,
internal motor protection
prevents a re-enabling of
the compressor for 1-3
hours.
■ If required, replace full
wave soft starter (if
installed); have com-
pressor checked by
refrigeration engineer.
Troubleshooting
Control unit diagnostics
(cont.)
5414 828 GB