Diagnostics
System console diagnostics allow a manager to test all of the keys on
and the
devices, as well as the pan and tilt functions.
1. To test communication on the Control Out, RS-422
and
ports, use
short jumper wires to make the following connections with the power disconnected from your system
console. Otherwise, skip to step 5 but choose Disabled.
Note: Pin
orientation is:
into the connector on the rear of the system console.
1
Control Out Connector:
2
3
4
5
6
7
9
1 0
1 1
1 4
1 5
1 6
1 7
1 2
1 9
2 1
22
23
24
25
RS-232, RS-485, AUX Connector:
2
4
3
5
RS-422
Connector:
4
5
2 .
Re-enter the system console by entering your user ID (and passcode, if necessary)
3 .
Press and hold the Shift
key and then press the F5 key to enter the Main Setup screen.
4 .
Press the System soft key and then use the up/down arrow soft keys to select Mode Selection. From the
next screen, select Diagnostics.
5 .
To start the test, use the up/down arrow soft keys to select Enabled.
Use the arrow keys to change selection
followed by the ENTER key or press EXIT
to return to the previous screen.
I 0 Diagnostic
DISABLED
Note: I/O testing requires special cables
on both the RS422 and Video Switch ports
6 .
Press the Enter soft key to display the following screen,
l
Diagnostics
X923 Rev 1099 System Console
