Installation:
(A
Warning: Do not apply power to any unit until all connections are properly made.
I
Make
connections as shown in the figure and tables below. Refer to page 52 for cable recommendations.
You may use the supplied RJ45 Termination Box to organize your cable runs and provide easy wiring from
the
Multi-System Selector. Using the termination box is not a required installation step. You
can connect power directly to the AC 2-pin connector or you may use the termination box and the
connector. Cut the
connector from the power supply, strip the wires and screw the
wires to the RJ45 Termination Box. The termination box has eight labeled connecting screws. To
determine which connection to make to which screw, refer to the table in Figure 9.
You may connect:
.
Multi-System
Selector, which may be
connected to 8 NOVA control
systems
.
8
Multi-Output
interface devices, each
c o n n e c t e d t o 4
1
device
1 joystick device
2 auxiliary devices
7 a d d i t i o n a l
Remote
Keyboards
can
only access 4
and
system consoles (can access
8
You may have to look closely at
the RJ45 Termination Box to see
the screw numbers (they are
embossed in the plastic). Pin is
shown below,
with numbers
increasing clockwise.
you do not route power
through the
Termination
connect the appropriate
power supply to this connector:
for
VAC.
230 VAC.
or
SYSTEM CONSOLE REAR PANEL
Power
with cable supplied.
Figure
Installation
System Console
Connector
Note: To connect a video
printer,
connect Aux 1
(pin 8) to the tip of a
stereo
jack. Connect
GND (pin 7) to the sleeve
o f a s t e r e o
jack.
Insert the
jack into
the “Remote 2” jack on
the back of the video
printer.
10
l
Installation:
X923 Rev 1099 System Console
