Installation: Standalone System
Warning: Do not apply power any unit until all connections are properly made.
Make connections as shown in the figure and tables below. Refer to page 52 for cable recommendations.
You may use the supplied RJ45 Termination Box to organize your cable runs and provide easy wiring from
the receiver or distribution line control. Using the termination box is not required. You can connect power
directly to the AC 2-pin connector or you may use the termination box and the
connector.
Cut the
connector from the power supply, strip the wires and screw the wires to the RJ45
Termination Box. The termination box has eight labeled connecting screws. To determine which
connection to make to which screw, refer to the table in Figure 2.
You may connect:
.
255 receivers
.
1 matrix switcher
.
1 joystick device
.
2 auxiliary devices
.
1
device
.
7 additional
and system consoles
You
may have to look closely at
the RJ45 Termination Box to
see the screw numbers (they
are embossed in the plastic).
Pin is shown below. with
If you do not route power
through the RJ45 Termination
connect the appropriate
power supply to this connector:
for 120 VAC.
for 230 VAC.
Connect to
400X.DJT or
card cage’s Control
A U X
SYSTEM CONSOLE REAR PANEL
RJ45 Termination
Box (supplied)
Connect to
Control Panels and/or
System Consoles (1 master, 7 additional).
Connect a printer or other W-232 device.
Power supply
cable supplied.
Cable supplied in accessory kit.
Figure 2
Standalone installation
Connect to
or W-232”
device(s). Connect to auxiliary
devices.
System Console
AUX” Connector
Devices
4
Installation: Standalone System
X923 Rev 1099 System Console