Installation: AURORA/VCR ONLY
Warning: Do not apply power to any unit until all connections are properly made.
I
Make connections as shown in the figure and tables below. Refer to page 52 for cable recommendations.
You may use the supplied RJ45 Termination Box to organize your cable runs. Using the termination box is
not required. You can connect power directly to the AC
connector or you may use the termination
box and the
connector. Cut the 2-pin connector from the power supply, strip the wires and
screw the wires to the RJ45 Termination Box. The termination box has eight labeled connecting screws.
To determine which connection to make to which screw, refer to the table in Figure 4.
You may connect:
.
8
Multi-Output
interface devices, each
c o n n e c t e d t o 4
.
joystick device
.
2 auxiliary devices
.
1 W-232 device
.
7 a d d i t i o n a l
Remote
Keyboards
can
only access 4
and system consoles (can
access 8
If you do not route power
through the RJ45 Termination
Box, connect the appropriate
power supply to this connector:
120 VAC for
230 VAC for
Termination
You may have to look closely at
the
Termination Box to
see the screw numbers (they
are embossed in the
Connect to
to use
and VCRs.
Connect to
Keyboards
System Consoles (up to 7 additional).
Connect to a printer, host computer or other
device.
Power supply with cable
. .
Cable supplied.
Figure 4
AURORA/VCR ONLY installation
Connect to RS-485’ or
device(s). Connect to auxiliary
devices.
System Console “FiS232,
AUX” Connector.
Auxiliary Devices
6
l
Installation: AURORA/VCR ONLY
X923 Rev 1099 System Console
