Alarms
Defining Buzzer Control
You may define that a buzzer sounds when an alarm is activated under the following conditions:
l
an alarm occurs at the NOVA control system (only NOVA/AURORA/VCR and
MS-S/NOVA/AURORA/VCR systems include control systems)
l
you make an entry error from the system console front panel
l
F6 and/or F8 activate an auxiliary device (you must have F6 Auxl Control F8 Aux 2
Control set to ON as discussed on page
21).
To set the alarm buzzer for each of the conditions above, perform the following steps:
Press and hold the Shift
key and then press the F5 key to display the Main Setup screen.
2 .
Then press the Alarm soft key. The Select Alarm Category screen will display.
Use the arrow keys to change selection
followed by the ENTER key or press EXIT
to return to the previous screen.
Select Alarm Category
ALARM CONTROL
INSTALL DEFAULTS
3 .
Use the up/down arrows to select Select Buzzer Control.
4 .
Press Enter to display the Buzzer Control screen,
Use the arrow keys to change selection
followed by the ENTER key to toggle the
ENABLE/DISABLE setting. Press EXIT to
store and return to the previous screen.
Buzzer Control
NOVA ALARM = DISABLED
ENTRY ERROR DISABLED
F6 CONTROL ENABLED
CONTROL DISABLED
5 .
Use the up/down arrows to select each line in turn, pressing the Enter key to toggle between Disabled and
Enabled.
6 .
Press Exit to save these settings and exit the screen.
30
l
Alarms
X923
Rev 1099
System Console