VESPA 946 E4 EMEA 2021, Manual

Page: 16 / 283

- Total odometer (ODO)
- Partial odometer (TRIP)
For this indicator « C » and for the speed indicator « B » the unit of measurement can be changed (from
Km to Miles and from Kph to mph) with the following procedure:
- move the key to « OFF »;
- press the MODE button to the left;
- Holding in the MODE button, turn the key to the « ON » position;
- after about 2 seconds release the MODE button.
WARNING
TO SWITCH FROM km/h TO mph, THE MULTIFUNCTION INDICATOR "C" MUST BE SET TO TO-
TAL ODOMETER (ODO).
N.B.
THE FOLLOWING ARE DEFINED WHEN NAVIGATING THE DISPLAY:
- «BRIEF PRESS»: A PRESS OF THE INDICATED BUTTON, FOR A PERIOD OF LESS THAN TWO
SECONDS;
- «PROLONGED PRESS»: A PRESS OF THE INDICATED BUTTON, FOR A PERIOD OF MORE
THAN TWO SECONDS.
CLOCK SETTING
To set or adjust the clock, with the vehicle running
or with key inserted in " ON " position, proceed as
follows:
- short press the MODE button to the left in se-
quence until the clock appears on the display;
- long press to the left to enter the hour display;
- adjust the hour by short pressing the MODE but-
ton to the left;
- with a long press, the set value is confirmed (or
present value if not modified) and it goes on to the
minutes display
- adjust the minutes by short pressing the MODE
button to the left;
- after a few seconds the set or changed time will
be displayed.
WARNING
FOR SAFETY REASONS THE TIME SETTING IS ONLY
POSSIBLE WITH THE VEHICLE AT A STANDSTILL.
WARNING
DETACHING THE BATTERY CABLES IMPLIES RESET-
TING THE CLOCK, WHICH WILL SHOW «12:00» UNTIL IT
IS ADJUSTED AGAIN, AND RESETTING OF THE TRIP OD-
OMETER.
Pre-delivery
Vespa 946 E4-E5 EMEA-USA-ASIA (2021-)
PRE DE - 16