Vertical WAVE IP 2500, Installation Manual

Page: 81 / 236

Installing expansion components 4
-
19
Chapter 4: Setting Up the Wave IP 2500 Server
Wave Server Installation Guide
Installing expansion modules and cards
This section provides guidelines for installing all modules and cards. See “About connecting
modules and cards” on page 4-20 for information on connecting trunks, stations, and other
devices to specific modules and cards after you have installed them.
Caution:
The Wave Server’s analog station interface is not designed to withstand surges
commonly associated with wires that are exposed to the external environment. Do not route the
wires connecting analog station cards or modules to stations outside the building where the
Wave Server is located.
Note: Because the required steps are different, installing a Media Resource Module is covered
separately on page 4-17.
To install modules and cards:
1. Unplug the Wave Server base unit’s power cord and the power cords of all EXUs, but do
not disconnect the grounding wires.
2. Remove the blank module or universal slot faceplate.
3. Insert modules and cards carefully.
• Note the position of the circuit board installation guides—there are 2 guides per
slot:
• Modules align with the bottom guide.
• Cards align with the top guide.
• Note the position of slot connectors:
• The ISC1 slot and module slots have a single slot connector.
• Universal slots have 2 slot connectors.
• Modules connect to the bottom slot connector.
• Cards connect to the top slot connector
4. Seat the module or card properly for good electrical connection. Engage the black
insertion lever, and tighten all faceplate mounting screws.
5. To install a partial-width module in a full-width universal slot, use a Wave IP 2500
module converter. First, screw the module into the converter, and then insert the
converter into the universal slot.
6. Install blank faceplates on all unused slots.
7. Reconnect the Wave Server base unit and all EXUs to power.
Release 4.0 June 20, 2013