Vertical WAVE IP 2500, Installation Manual

Page: 100 / 236

Connecting to the Wave ISM 5
-
6
Chapter 5: Connecting to the Wave ISM from the administrator PC
Wave Server Installation Guide
Connecting to the Wave Server via your network
This section describes how to connect to the Wave ISM from the administrator PC using a
standard Ethernet cable. (You can also connect using a network hub, switch, or router.)
1. Connect one end of a standard, straight-through Ethernet cable to the network card in the
administrator PC. Connect the other end of the cable to the RJ-45 Ethernet port, labeled
ENET 1 on the front of the ISC1 (Wave IP 2500), or ENET on the front of the ISC2
(Wave IP 500).
Important: On the Wave IP 2500, ENET 1 is the Wave Server’s primary interface and
under normal conditions it is the only interface that should be connected to your LAN . The
port labeled ENET 2 is only used in special circumstances, as described in “About the
Ethernet ports on the Wave IP 2500 Server” on page 4-13.
2. Launch Microsoft Internet Explorer. If the administrator PC is running Windows XP SP2
or higher, go to step 3. Else, go to step 5.
3.
Warning:
In Windows XP SP2, Microsoft enhanced the default browser security
in Internet Explorer. These security defaults affect the functionality of the Global
Administrator Management Console (for example, by disabling or hiding some
applets). To ensure that you do not encounter any problems when using the
Management Console, perform the following steps:
1. On the administrator PC, in Internet Explorer choose
Tools > Internet Options
.
2. On the Privacy tab, click
Settings
in the Pop-up Blocker section. (If
Settings
is
disabled, select the
Block pop-ups
checkbox first.)
3. In the Pop-up Blocker Settings dialog, enter one of the following in the
Address of
Web site to allow
text box:
• IP address . Enter the default IP address of the Vertical Application Module
(VAM) in the Wave Server (
192.168.205.1
), or the VAM’s IP address on
your system if you have changed it).
• DNS-resolvable name . For example,
yourservername
Note: Do not preface your entry with “
http://
”.
4. Click
Add
and then
Close
to save your changes.
Release 4.0 June 20, 2013