Vertical WAVE IP 2500, Installation Manual

Page: 126 / 236

Setting the dial-in default IP address pool 7
-
14
Chapter 7: Initial Configuration
Wave Server Installation Guide
Setting the dial-in default IP address pool
Before the Wave ISM will allow dial-in connections, you must set the IP address pool for those
connections. Because this is an internal pool of addresses, obtain the appropriate settings from
your company’s system administration group.
All Wave ISMs ship with the same default IP address pool. Enabling a routing protocol such as
RIP or OSPF on the Wave ISM causes it to advertise a route to that address pool. If you choose
not to change the default IP address pool, each Wave ISM will advertise a route to the same IP
address pool, which may result in network problems.
To set the dial-in default IP address pool:
1. In the Global Administrator Management Console, click
Microsoft RRAS
, located in the
Data Administration section.
2. Log on using your Wave username and password.
3. The Microsoft RRAS applet launches the Microsoft Routing and Remote Access
application in a remote control window that allows the application running on the Wave
ISM to appear on the administrator PC. (For more information, see “Remote Access
Application applets” in Chapter 25 in the
Wave Global Administrator Guide .)
Click
Yes
if you are asked if you trust the computer to which you are connecting.
4. In the Routing and Remote Access dialog, select the Wave ISM in the tree in the left
pane.
5. Choose
Action > Properties
.
6. On the IP tab, select
Static address pool
.
7. Click
Add
to define the IP address pool.
Release 4.0 June 20, 2013