VALCO MELTON D10, Manual

Page: 263 / 313

8 Valco Melton
IS0161 Handgun Switch Kit Installation and Operation
Input Setup
1. On the Power Board (151xx614), set “Switch 1” UP to the FILL
position. See Figure above.
2. For Variable Speed Units (with a VFD) only: Locate the Motor
Control Board on the back side of the keypad and make sure
SW1 is in the FIX position. See figure below.
For Fixed Speed
Units, skip step 2 and
proceed to step 3.
3. Setup is complete.
Testing
1. Connect the hose/handgun to the D10 Unit.
2. Connect the 4-pin circular connector from the Handgun Switch
Cable installed, to the mating connector from the hose.
3. Turn ON the unit and wait for all zones to reach temperature and
for the System Ready light to come on.
4. Enable the Pump by pressing the Manual Pump On/Off on the
Keypad.
5. Pull the handgun trigger to activate the pump. Testing is
successful when the pump is enabled during the time the trigger
is held.
To tell if the pump is
enabled when the
trigger is held, listen
for the sound of the
pump activating. Also,
if there is glue in the
system, the handgun
will dispense glue.