VALCO MELTON D10, Manual

Page: 100 / 313

Section 6 - Operation MM113 - D10/D16 Hot Melt Unit
100
Temperature
The tank temperature screen will show the actual tank temperature and the tank temperature setpoint. For operator
convenience, the right side of the display screen alternately displays the Hose & Gun temperatures (see Section 5 –
Setup, for setting zone temperatures). Press the Heater Key (or use the Navigation Buttons) to cycle through the
temperature screens until you reach the desired screen.
Setpoint and Actual Temperature
Temperature Status LEDs
The Control Panel contains LEDs that indicate the status of each heated zone. When the zone is in warm-up mode,
the zone LED will illuminate green and stay on continuously. Once the zone reaches its setpoint temperature, the LED
will blink on and off indicating that the heaters are switching on and off to maintain the setpoint temperature. If the
LED illuminates red, it indicates a fault for that zone. The status bar will provide a more detailed explanation of the
fault. Also, if the fault triggers a temperature alarm, the Temperature Alarm LED will illuminate red (see
Section 5 -
Setup, “Over Temperature Alarm” and “Under Temperature Alarm”
for details).
Actual Temperature
Setpoint Temperature
Tank Heater LED
Hose Zone LEDs Gun Zone LEDs
Heater
(Temperature)
Menu Key & LED
Tank Heater LED
Hose Zone LEDs Gun Zone LEDs
System Ready LED
Warning/Alarm LED