7.1
95-8533
4-25
DCIO Startup
1. The Power-on LED should be illuminated. The
Fault LED should blink once on power up, then
remain off.
2. The input circuits should indicate the proper state
of the input device (channel active LED illuminates
when the circuit is closed). Check the input
power supply and associated wiring. Verify
proper voltage per the Troubleshooting matrix.
3. The output circuits should indicate the proper
state for the programmed device (channel active
LED illuminates when the circuit is active). Check
the power supply and associated wiring. Verify
proper voltage per the Troubleshooting matrix.
4. The circuits should not indicate a fault condition
(channel fault LED illuminates when the circuit is
in fault). Check the end-of-line devices and
associated wiring. Verify proper voltage per the
Troubleshooting matrix.
5. Test the entire system for proper operation to
ensure that the configuration was performed
properly.
Relay Module Startup
1. The Power-on LED should be illuminated. The
Fault LED should blink once on power up, then
remain off.
2. The output circuits should indicate the proper
state for the programmed device (channel active
LED illuminates when the circuit is active).
3. Test the entire system for proper operation to
ensure that the configuration was performed
properly.
Analog Input Module Startup
1. The Power-on LED should be illuminated. The
Fault LED should blink once on power up, then
remain off.
2. The input circuits should indicate the proper state
for the programmed device (channel active LED
illuminates when the circuit is active).
3. The circuits should not indicate a fault condition
(channel fault LED illuminates when the circuit is
in fault).
4. Test the entire system for proper operation to
ensure that the configuration was performed
properly.
Intelligent Protection Module Startup
1. The Power-on LED should be illuminated. The
Fault LED should blink once on power up, then
remain off.
2. The output circuits should indicate the proper
state for the programmed device (channel active
LED illuminates when the circuit is active).
3. The circuits should not indicate a fault condition
(channel fault LED illuminates when the circuit is
in fault).
4. Test the entire system for proper operation to
ensure that the configuration was performed
properly.
Summary of Contents for DET-TRONICS 95-8533
