259
Configuration Examples
EdgeSwitch
™
Administration Guide
Ubiquiti Networks, Inc.
Appendix A: Configuration Examples
This appendix contains examples of how to configure selected features available in the EdgeSwitch software.
Each example contains procedures on how to configure the feature by using the EdgeSwitch UI or CLI.
This appendix describes how to perform the following procedures:
•
“Configuring VLANs” on page 259
•
“Configuring Multiple Spanning Tree Protocol” on page 262
•
“Configuring VLAN Routing” on page 265
•
“Configuring Policy-Based Routing” on page 267
•
“Configuring 802.1X Network Access Control” on page 270
•
“Configuring Differentiated Services for VoIP” on page 271
Note:
Each configuration example starts from a factory-default configuration unless otherwise noted.
Configuring VLANs
The diagram in this section shows a switch with four ports configured to handle the traffic for two VLANs.
Port 0/2 handles traffic for both VLANs, while port 0/1 is a member of VLAN 2 only, and ports 0/3 and 0/4 are
members of VLAN 3 only.
The following examples show how to create VLANs, assign ports to the VLANs, and assign a VLAN as the
default VLAN to a port.
24V
Port 0/1
VLAN 2
Port 0/4
VLAN 3
24V
24V
24V
Layer 3 Switch
VLAN 2
VLAN 3
Port 0/3
VLAN 3
Port 0/2
VLAN 2 & 3
24V
VLAN Example Network Diagram
Using the EdgeSwitch UI to Configure VLANs
1. Access the
Switching
>
VLAN
>
Status
page.
2. Click
Add
to create a new VLAN.
