Trio Motion Coordinator Euro 205, Technical Reference Manual

Page: 171 / 566

6-13 System Setup and Diagnostics
Diagnostic Checklists
Trio Motion Technology
Diagnostic Checklists
Problem Potential reasons
No Status LEDs on any mod-
ule • Power Supply
LEDs lit on Master but not
on other modules • Ribbon cable / Bank select switch
OK LED ON &
Status LED flashing • Following error on at least one axis. The axis
demand position and measured position
exceed the programmed limit
Motor runs away without
issuing a move command • tacho/drive polarity
• encoder/controller polarity
• gains (drive and/or controller)
Motor runs away upon issu-
ing a move command • tacho feedback
• encoder feedback
• gains (drive and/or controller)
Motor does not move upon
issuing a move command • wiring (enables/inhibits/limits on drive and
controller)
• check status on all axes
• drive power
• feedhold applied
• speed, acceleration and/or deceleration set to
zero
• servo set off/watchdog set off
• gains (drive and/or controller)
• axis is already running a move which has not
completed - Check MTYPE and NTYPE
Axis goes out on following
error after a time • speed being requested requires more than 10v
- check drive tacho gain and motor/ drive
speed characteristics.
• drive shutting down on current limit after a
time