TransCore SmartPass AI1611, System Manual

Page: 163 / 179

SmartPass® Integrated Reader 2450 MHz (High Voltage) System Guide
6171 Enable Echo Mode (Factory Default)
Command 6171 enables the reader to echo received host commands. Refer to
command 6170 for more information.
Reader message:
Done or Erro
r
620N Output Control
These commands provide direct control of two output lines that may be used to
operate external hardware such as gates or traffic lights. Receipt of any 620N
command automatically disables predefined output mode command 621. The value
for
N
specifies the output status as follows:
Table 9-13 Output Control Option Commands
Command Output Control Option
6200 Turn both output ports off
6201 Turn output0 on, output1 off
6202 Turn output1 on, output0 off
6203 Turn both output ports on
Reader message:
Done
The host will not be able to directly control output1 if either Wiegand mode
(command 451) or the external check tag option (command 8161) is enabled.
621 Predefined Output Control (Factory Default)
Command 621 configures the reader for predefined output mode. In this mode, both
output lines, output0 and output1, are automatically asserted upon receipt of a valid
unique tag ID. The output line will remain asserted for the time specified by output
pulse duration (command 67N). Any direct control command (620N) will
automatically disable predefined output mode.
Reader message:
Done
If predefined output mode is enabled, the reader will not assert output1 upon receipt
of a tag ID if Wiegand mode is enabled (command 451) or if the external check tag
option is enabled (command 8161).
63 Reset Reader
Command 63 resets the power fail bit, clears all buffers, resets tag uniqueness, turns
both output lines off, transmits the sign-on message, and returns to the data mode.
Reader message:
Model [software version] SNYYYYYY
[Copyright notice]
9-40