TransCore SmartPass AI1611, System Manual

Page: 165 / 179

SmartPass® Integrated Reader 2450 MHz (High Voltage) System Guide
65 Reset Power Fail Bit
Command 65 resets the power fail bit to zero. The bit changes from 0 to 1 when
power is restored to the reader. Upon reader power up, the host should transmit
either this command 65 or the reset reader command 63 to properly initialize this bit.
The current state of the power fail bit may be displayed. Refer to display power fail
bit command 520 for more information.
Reader message:
Done
660 Test External RAM
Command 660 performs a read/write test of external data memory (32 K). The
contents of RAM are not disturbed by this test. Command 660 updates information
displayed by the display diagnostic results command (command 661).
Reader message:
Done
passed RAM test
Error
failed RAM test
661 Display Diagnostic Results
Command 661 displays the results of previously performed diagnostics. The
information displayed by this command is updated when the reader receives any
diagnostic command. This information is preserved after power down. Executing
command 669 updates every field in this message. If diagnostics have never been
performed, the information displayed by this command is not predictable.
Reader message:
DIAG R<0-1> E<0-1> D<0-1> C<0-1>
where
R0
boot ROM OK
R1
boot failed
E0
flash memory OK
E1
flash memory failed
D0
external RAM OK
D1
external RAM failed
C0
RTC OK
C1
RTC failed
9-42