TransCore SmartPass AI1611, System Manual

Page: 132 / 179

Commands
Number Command Name Reader Message
6140 Disable flow control Done
6141 Enable software flow
control Done
6142 Enable hardware flow control Done
6160 Disable buffer control
mode Done
6161 Enable buffer control mode Done
6170 Disable echo Done
6171 Enable echo Done or Error
6200 Turn both outputs off Done
6201 Turn output0 on Done
6202 Turn output1 on Done
6203 Turn both outputs on Done
621 Select predefined output
mode Done
63 Reset reader Model [model]
Ver [Ver no.] SN [serial no.]
Copyright [date]
TransCore
6400 Turn RF off Done
6401 Turn RF on Done
641 Select RF-by-input control Done
65 Reset power fail bit Done
660 Test external RAM Done or Error
661 Display diagnostic results DIAG Rx Ex Dx Cx
R0 = boot ROM OK
R1 = boot failed
E0 = flash memory OK
E1 = flash failed
D0 = external RAM OK
D1 = RAM failed
C0 = RTC OK
C1 = RTC failed
664 Test real-time clock Done or Error
667 Verify boot ROM checksum Done or Error
668 Verify flash memory
checksum Done or Error
669 Perform all diagnostics
Use 661 to display diagnostic
results Done or Error
66F Load default operating
parameters
Done or Error
67N Set output pulse duration
N = 0–F
(4,8,12,16,20,24,32,40,48 Done or Error
9-9