TransCore SmartPass AI1611, System Manual

Page: 61 / 179

Quick SmartPass® Test
7. Pass one test tag in front of your SmartPass. The green light on the screen
illuminates.
Note: An internal timer in SmartPass causes SmartPass to ignore a specific
tag for 2 minutes after a good read unless a different tag is read in the
meantime.
8. Pass a different test tag in front of your SmartPass. The green light on the
screen illuminates.
If SmartPass reads both tags, your SmartPass is ready to install.
Table 3-5 shows the factory defaults for SmartPass.
Table 3-5 Factory Defaults for SmartPass
Parameter Setting Command
Operating mode Data 00
Baud rate 9600 1005
Stop bits 1 1010
Parity None 1020
End-of-line delay 0 ms 1030*
Time and date appended Enabled 302
Auxiliary information appended Disabled 310
Unique ID code criteria Separation of 1 ID 4100
Valid ID code criteria 1 acquisition 4200*
Uniqueness timeout 2 minutes 441*
Wiegand mode Disabled 450
Tag translation mode Disabled 452
Wiegand transmit mode 1 second 4601
Dual processing mode Reset on A
Transmit on A 4800
Reader ID number 00 6000
Communications protocol Basic 610
ECP (error correcting protocol) timeout 12.7 sec 612FE
Flow control Software (XON/XOFF) 6141
Start-of-message character # (23 hex) 6150*
Buffer control mode Disabled 6160
Echo mode Enabled 6171
Output control Predefined 621
RF-by-input control Enabled 641
Output pulse duration 228 ms 67C
Presence without tag reports Disabled 6900
Minimum presence true period 0 ms 6910*
RF-off control Timeout or no
presence 6922
RF timeout Never true 693F
Input inversion Disabled 6940
3-9