TransCore SmartPass AI1611, System Manual

Page: 173 / 179

SmartPass® Integrated Reader 2450 MHz (High Voltage) System Guide
96 Erase Flash Memory
Command 96 erases the flash memory. Once this command is executed, exit from
download mode will not be possible until a new program is loaded into flash
memory.
Reader message:
Done
97 Perform Destructive Flash Test
Command 97 performs a test on the flash memory. Various patterns are programmed
into the memory and verified. This test writes over any program previously stored in
the flash memory; therefore, a download of software will be required afterwards. .
Once this command is executed, exit from download mode will not be possible until
a new program is loaded into flash memory.
Reader message:
Done
flash memory is OK
Error
flash memory failed
99 Exit Download Mode
Command 99 instructs the reader to exit download mode. The reader will re-execute
startup to ensure proper initialization of the reader. If the flash memory checksum
verifies, the reader will display the sign-on message shown below and will enter data
mode.
Reader message:
Model [Model] Ver [software version] SNYYYYYY
[Copyright notice
]
where
YYYYYY
is the serial number expressed in decimal digits
(0–9) with the first two digits representing the year
If the flash checksum does not verify, the reader will come up in download mode and
will transmit the sign-on message shown below:
Model [Model] Ver 0.00
[Copyright notice
]
9-50