TransCore SmartPass AI1611, System Manual

Page: 151 / 179

SmartPass® Integrated Reader 2450 MHz (High Voltage) System Guide
522 Display Communication Port Parameters
Command 522 displays the selected communications port parameters including the
baud rate (100N), the number of stop bits (101N), the parity scheme (102N) and the
end-of-line delay.
Reader message:
MAIN B<0-6> S<0-1> P<0-2> D0
where
B0
110 baud
B1
300 baud
B2 1200 baud
B3 2400 baud
B4 4800 baud
B5 9600 baud (factory default)
B6 19.2 kbps
S0 one stop bit (factory default)
S1 two stop bits
P0 no parity (factory default)
P1 even parity
P2 odd parity
D0 00 ms end-of-line delay (fixed)
One space is between each value. For example, if factory default settings are
assigned, the reader message is:
MAIN B5 S0 P0 D0
9600 baud, one stop bit, no parity, and 0 ms end-of-line delay
Note: The information transmitted in response to this command applies to data
and command mode operation only. While operating in download mode,
default communication parameters are always used.
524 Display Appended Information Status
Command 524 displays the information being appended to the reader transmissions.
Appended information is selected using command 30N to append time and date
selection and command 31N to append auxiliary information.
Reader message:
IDAP T<0-1> D<0-1> X<0-1>
where
T0
time is not appended
9-28