TransCore SmartPass AI1611, System Manual

Page: 152 / 179

Commands
T1
time is appended (factory default)
D0
date is not appended
D1
date is appended (factory default)
X0
auxiliary information is not appended (factory default)
X1
auxiliary information appended
There is one space between each value. For example, if factory default settings are
assigned, the reader response is:
IDAP T1 D1 X0
Time and date are appended and auxiliary information is not appended.
Note: Time and date may be appended to ID codes, error messages, presence
without tag reports, and input status change reports. Auxiliary information
may be appended to only ID codes, presence without tag reports, and input
change reports.
525 Display Communication Protocol Status
Command 525 displays selected communications protocol command 61N, selected
mode of flow control command 614N, and ECP timeout command 612NN.
Reader message:
ECPS P<0-2> T<01-FF> X<0-2>
where
P0
basic protocol enabled (factory default)
P1
error correcting protocol enabled
P2
data inquiry protocol enabled
Txx
ECP timeout where xx = 01–FE (hexadecimal)
timeout (ms) = 50 * xx
if xx = FF timeout is disabled
X0
flow control disabled
X1
software flow control enabled (factory default)
X2
hardware flow control enabled
For example, if factory default settings are assigned, reader message is:
ECPS P0 TFE X
1
Basic protocol enabled, an error correcting protocol timeout of 254 (12,700 ms, 12.7
sec), and software flow control enabled
9-29