Toyota 02-8FDF15, Operator'S Manual

Page: 48 / 392

en
en-47
(1) Radiator cover
Checking the engine coolant level
in radiator
1. Remove the radiator cover.
2. Remove the cap and check the coolant
level from the filler port.
3. If the engine coolant is not visible
through the filler port, fill appropriately
diluted coolant (LLC) to the port.
Note:
To close and tighten the radiator cap, match the
pawl on the reverse side of the cap with the
notch on the filler port and turn the cap fully
clockwise while applying a downward force.
Warning
When the engine is hot, it is very dangerous
to remove the cap. Coolant level check must
always be performed when the engine is
cold.
Checking hydraulic oil level
Always stop the engine and lower the forks to
the ground before checking the level of the
hydraulic oil, while the vehicle is on level
ground.
1.
Open the engine hood and remove the oil
cap.
2. Wipe the level gauge attached to the oil
cap with clean cloth, and insert it again
into the tank.
Note:
Inspect the oil level by placing the level gauge
on the opening of the oil supply inlet, without
pushing the oil cap in.
(1)
(1) Oil cap
(2) Level gauge
(3) Gauge identifier
(4) Lift high 6,100–7,000mm
(5) Lift high 5,500–6,000mm
(6) Lift high 4,500–5,000mm
(7) Lift high 3,300–4,000mm
(8) Lift high 3,000mm or less
3. Extract the level gauge gently and check
if the oil adhesion is up to the level line.
4. If the oil level is insufficient, add oil.
Spilled and splashed oil must be wiped
off thoroughly. Adjust the oil level so that
it will fall within a range of 0 thru
+10mm from the lift-high mark on the
gauge as illustrated on the left side.
Engine oil inspection
1. Park the vehicle on a flat ground. If the
vehicle is inclined, the indicated level
may be incorrect.
2. The oil level must be checked before
starting the engine or at least 3 minutes
after the engine is stopped.
3. Extract the oil level gauge and wipe it
with clean cloth. Insert it again and check
if the oil level is between the F and L lev-
els.
4. If the oil level is below the L line, add oil
to the F line.
(3)
(1)
(2)
(4)
(4)
(5)
(6)
(7)
(8)
Gauge Identifier Applicable Models
10, 18, K2, K3
02-8FGF15, 18
02-8FDF15, 18
02-8FGKF20
02-8FDKF20
32-8FGF15,18
62-8FDF15,18
20, 25
02-8FGF20, 25
02-8FDF20, 25
52-8FDF20, 25
32-8FGF20, 25
62-8DFD20, 25
28, 30, 35
02-8FGF30
02-8FDF30
52-8FDF30
02-8FGJF35
02-8FDJF35
52-8FDJF35
32-8FGF30
62-8FDF30
32-8FGJF35
01_A5028-0EA04_En.fm 47 ページ ２０１２年１２月６日 木曜日 午後１２時４２分