Installing the Reel Drive Assembly
1. Install all the components that were removed to the reel drive housing (
). If the ball bearings (item 8 in
) were removed from the idler
shaft, use a press to install new bearings and the bearing spacer onto the
shaft.
2. Apply a light coating of grease on the reel drive housing O-rings (items 4
and 23 in
3. Position the reel drive assembly to the cutting unit. Ensure that the spring pin
(item 26 in
) and compression spring are positioned between the
reel drive housing and the bearing housing assembly.
4. Secure the reel drive assembly with the 2 flange-head screws (item 20 in
) and washer-head screw.
5. Install the woodruff key to the reel driveshaft (item 21 in
). Apply
anti-seize lubricant at the top of the key.
6. Slide the reel pulley (item 18 in
) onto the reel driveshaft until it
contacts the shoulder on the shaft. Secure the reel pulley with the 2 set
screws; torque the set screws to
8.3 to 8.9 N∙m (74 to 79 in-lb)
.
7. Install the reel drive belt; refer to
Reel Drive Belt (page 4–14)
. Ensure that
the reel drive cover is secured to the housing after the belt installation.
8. Slide the telescoping coupler onto the cutting unit hex shaft (
).
9. Connect the battery pack; refer to
Connecting the Lithium Battery Pack
(page 4–3)
.
Traction and Reel Drive System: Service and Repairs
Page 4–18
Greensmaster
®
eFlex 1800, 2100 and 2120
12189SL Rev E
