While Operating the Machine
1. Always stand behind the handle when starting and operating the machine.
2. To begin the machine operation:
A. Ensure that the machine wire harness is connected to the battery pack.
B. Check that the control lever on the handle is in the N
EUTRAL
position
for both traction and reel drives.
C. Turn the key switch to the S
TART
position until the InfoCenter display
lights up, then release the switch to the R
UN
position.
3. Before leaving the operator’s position of the mower:
A. Stop the machine on a level ground.
B. Disengage both the traction and reel drives with the control lever and
set the parking brake.
C. Turn the key switch to the O
FF
position and wait for all the machine
movement to stop.
4. Before you remove the basket of clippings, disengage the traction and reel
drives, set the parking brake, turn the key switch to the O
FF
position and wait
for the electric motor to stop. Wait for all the machine movement to stop
before removing the basket.
5. If the cutting unit strikes a solid object or vibrates abnormally, stop the
machine operation immediately. Disengage the traction/mow lever, turn the
key switch to the O
FF
position, wait for all the machine movement to stop.
Then, disconnect the battery pack (refer to
Connecting the Lithium Battery
) and inspect the cutting unit for damage. A damaged reel or
bedknife must be repaired or replaced before operation is started.
6. Whenever the machine is left unattended, ensure that the electric motor
is stopped, cutting unit reel is not spinning, and key switch is in the O
FF
position. Remove the key from the key switch.
Safety: Safety Instructions
Page 1–4
Greensmaster
®
eFlex 1800, 2100 and 2120
12189SL Rev E
