Installing the Rear Roller
1. Place the cutting unit on a level working surface.
Note:
Refer to
Cutting Unit Operator’s Manual
for number of roller shims
required for various height-of-cut settings.
2. If both the rear roller brackets were removed from the cutting unit side plate,
position the brackets and roller shims to 1 of the side plates. Install the 2
carriage screws and 2 flange nuts to retain the bracket in position. Do not
fully tighten the flange nuts.
3. Slide the rear roller shaft into the rear roller bracket attached to the cutting
unit. Slide the second rear roller bracket onto the other end of the roller shaft.
Secure the second roller bracket and shims to cutting unit side plate with the
2 carriage screws and 2 flange nuts. Do not fully tighten the flange nuts.
4. Center the rear roller to the cutting unit and secure in place by tightening
the 4 flange nuts.
5. Adjust the cutting unit; refer to the
Cutting Unit Operator's Manual
.
6. Install the cutting unit to the machine.
7. After all necessary adjustments have been made, connect the battery pack;
refer to
Connecting the Lithium Battery Pack (page 7–3)
.
Greensmaster
®
eFlex 1800, 2100 and 2120
Page 7–21
Cutting Unit: Service and Repairs
12189SL Rev E
