Toro Greensmaster eFlex 1800, Service Manual

Page: 267 / 312

Disassembling the Grooming Reel (continued)
1. Remove grooming reel from cutting unit; refer to Removing the Grooming
Reel (Forward Rotating Groomer Drive) (page 8–10) or Removing the
Grooming Reel (Counter Rotating Groomer Drive) (page 8–14) .
2. Remove locknut from either end of the shaft ( Figure 198 ).
IMPORTANT
If grooming reel is equipped with carbide tipped blades, note
position of blades on groomer shaft as they are removed. Correct
direction of blades is required for proper groomer operation.
3. Remove spacers and blades from groomer shaft as necessary.
Assembling the Grooming Reel
1. Start by placing thick spacer against the locknut installed on one end of
groomer shaft. Then, place first blade against installed spacer ( Figure 198 ).
IMPORTANT
If groomer is equipped with blades with carbide tips, ensure that the
blades are installed with the tips in the same, correct direction.
2. For 1.3 cm (1/2 inch) blade spacing, ensure there are 2 blade spacers
between blades ( Figure 198 ).
3. When all blades have been installed, place second thick spacer on shaft and
then thread second locknut onto the shaft.
g228297
Figure 199
1. Locknut 2. Center blades on shaft 3. Grooming shaft
4. Position locknuts to allow blades and spacers to be centered on the shaft
( Figure 199 ); torque locknuts to 23 to 28 N∙m (200 to 250 in-lb) so that
the spacers are not free to rotate.
5. Install grooming reel back onto cutting unit; refer to Installing the Grooming
Reel (Forward Rotating Groomer Drive) (page 8–12) or Installing the
Grooming Reel (Counter Rotating Groomer Drive) (page 8–16) .
Greensmaster ® eFlex 1800, 2100 and 2120 Page 8–19 Belt Driven Groomer: Service and Repairs
12189SL Rev E