Removing the Grooming Reel Bearing (continued)
6. Remove grooming reel seals and bearings from right drive plate and left
support plate assemblies (
,
, and
). Discard
all removed seals and bearings.
Installing the Grooming Reel Bearing
g228303
Figure 205
1.
Outer bearing
4.
Inner race
7.
Drive plate (right)
2.
Drive plate shoulder
5.
Seal lip
8.
Support plate (left)
3.
Inner bearing
6.
Support plate bearing
1. Install new grooming reel bearings and seals into right drive plate and left
support plate assemblies (
IMPORTANT
Bearings should be installed with extended inner races toward
center of housing. Also, apply pressure equally to inner and outer
bearing races when installing bearings.
A. Press new outer bearing fully to shoulder of right drive plate bore. Then,
install new inner bearing until inner race contacts outer bearing race.
B. Press new bearing into left support plate until it is flush with shoulder
of bearing bore.
C. Install new seals into groomer side plates.
Note:
Seals should be installed so that the lip side of the seal will face
the center of the cutting unit. When bearings are greased, grease will
purge from inner seals.
2. Install left support plate to left side of cutting unit:
A. Apply anti-seize lubricant to threads of left groomer arm lift rod.
B. Position support plate to cutting unit making sure that left groomer arm lift
rod is positioned through bushing in support plate.
C. Place spring washer and locknut on lift rod threads (
). Tighten
locknut.
D. Install reel drive assembly, reel pulley, reel drive belt and then reel drive
cover to left side of cutting unit; refer to
Reel Drive Assembly (page 4–16)
.
Belt Driven Groomer: Service and Repairs
Page 8–22
Greensmaster
®
eFlex 1800, 2100 and 2120
12189SL Rev E
